590 ExtremeWare Software 7.3.0 Command Reference Guide
SLB Commands
Following is the output from this command:
IP Freq/ TCP/UDP Frequency/Max
Node IP Address Flags Timeout Port Flags Timeout#PoolsConns
1.111.1.1 E--H-- 10/30 80 E--- 30/90 2(no limit)
1.111.1.2 E--H-- 10/30 80 E--- 30/90 2(no limit)
1.111.1.3 E--H-- 10/30 80 E--- 30/90 2(no limit)
Flags: E - Enable, U - Up, R - IP Route Up, H - Health check enabled,
P - Health check passed, ! - VLAN not configured with "slb-type"
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...