show slb vip
ExtremeWare Software 7.3.0 Command Reference Guide 595
Following is the output from this command:
Unit Export # Servers
Name IP Address Port -- Mode -- FlagsPool Up/Defined
ratio_vip 4.1.1.100 80 1 TL SR EUA-----ratio_po0/3
rr_vip 10.1.1.10 80 1 TP PA EUA----!rr_pool0/3
Modes: TP - Transparent, TL - Translational, PT - Port Translational
Automatically Exported via: PA - Proxy Arp, HR - Host Route, SR - Subnet Route
Flags: E - Enable, U - Up, A - Active Unit, H - Health-Check Enabled,
P - Persistence, S - Sticky, R - SvcDown-Reset,
! - VLAN has not been configured with "slb-type"
History
This command was first available in ExtremeWare 6.1.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...