630 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Status Monitoring and Statistics
source ipaddress 10.1.2.0/24
Using the single command eliminates the possibility of missing an event of interest between the
separate
delete
and
add
commands.
See the command
show log
on page 713 for a detailed description of severity levels.
To see the current configuration of a target, use the following command:
show log configuration target {console-display | memory-buffer | nvram | session |
syslog [<host name/ip> {: <udp-port>} [local0 ... local7]]}
To see the current configuration of a filter, use the following command:
show log configuration filter <filter name>
Example
To change the severity level of the filter item added with this command:
configure log filter bgpFilter2 add events bgp.keepalive severity notice
use the following command:
configure log filter bgpFilter2 set severity info events bgp.keepalive
History
This command was first available in ExtremeWare 7.1.0
Platform Availability
This command is available on all platforms.
To Next Page
Loading...