Extreme Networks ExtremeWare - Page 634

634 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Status Monitoring and Statistics
Default
The following defaults apply to console display, memory buffer, NVRAM, and session targets:
• timestamp—hundredths
• date—mm-dd-yyyy
• severity—on
• event-name—condition
• host-name—off
• priority—off
• tag-id—off
• tag-name—off
• sequence-number—off
• process-name—off
• process-id—off
• source-function—off
• source-line—off
The following defaults apply to syslog targets (per RFC 3164):
• timestamp—seconds
• date—mmm-dd
• severity—on
• event-name—none
• host-name—off
• priority—on
• tag-id—off
• tag-name—on
• sequence-number—off
• process-name—off
• process-id—off
• source-function—off
• source-line—off
Usage Guidelines
This command configures the format of the items that make up log messages. You can choose to include
or exclude items and set the format for those items, but you cannot vary the order in which the items
are assembled.
When applied to the targets console-display or session , the format specified is used for the messages
sent to the console display or telnet session. Configuration changes to the
session target, be it either a
telnet or console display target session, are in effect only for the duration of the session, and are not
saved in FLASH.