configure ssh2
ExtremeWare Software 7.3.0 Command Reference Guide 827
Example
The following command generates an authentication key for the SSH2 session:
configure ssh2 key
The command responds with the following messages:
WARNING: Generating new server host key
This will take approximately 10 minutes and cannot be canceled.
Continue? (y/n)
If you respond yes, the command prompts as follows:
Enter some random characters. End with a newline
Type in a series of random characters, and then press the Enter or Return key. The key generation
process will then proceed.
To configure an SSH2 session using a previously generated key, use the following command:
configure ssh2 key pregenerated
The command responds with the following message:
Please enter the server key
Enter the previously-generated key (you can copy and paste it from the saved configuration file).
History
This command was first available in ExtremeWare 6.0.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...
Need help?
General
