846 ExtremeWare Software 7.3.0 Command Reference Guide
Security Commands
NOTE
You can configure multiple DHCP address ranges for a VLAN. The start-addr option in the command
(50.0.0.5 in this example) specifies the exact DHCP address range for which the command applies. If
the last option is not specified, the command is applied for the primary subnet.
History
This command was first available in ExtremeWare 6.2.
This command was modified so that remote or secondary subnets could be configured for DHCP
options in ExtremeWare (through the addition of the parameter
start-addr
). This enhanced command
was made available in ExtremeWare 7.3.0.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...