create access-list udp destination source ports
ExtremeWare Software 7.3.0 Command Reference Guide 855
Example
The following command defines an access-list rule named allow10_35 with precedence 70 that permits
udp port 35 traffic destined for other 10.X.X.X networks, and assigns QoS profile Qp2:
create access-list allow10_35 udp dest 10.0.0.0/8 ip-port 35 source any ip-port any
permit qosprofile qp2 ports any precedence 70
History
This command was first available in ExtremeWare 6.0, and replaced the
configure ipqos
command.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...
Need help?
General
