992 ExtremeWare Software 7.3.0 Command Reference Guide
EAPS Commands
Example
The following command displays detailed EAPS information for domain “eaps2”:
show eaps eaps2 detail
The results for domain “eaps2” on a master node are shown as follows:
Name: “eaps2” (instance=0)
State: Complete [Running: Yes]
Enabled: Yes Mode: Master
Primary port: 14 Port status: Up Tag status: Tagged
Secondary port: 13 Port status: Blocked Tag status: Tagged
Hello Timer interval: 1 sec Fail Timer interval: 3 sec
Fail Timer expiry action: Send alert
Last update: From Master Id 00:01:30:B9:4B:E0, at Tue May 6 12:49:25 2003
Eaps Domain has following Controller Vlan:
Vlan Name VID
“rhsc” 0020
EAPS Domain has following Protected Vlan(s):
Vlan Name VID
“blue” 1003
“traffic” 1001
Number of Protected Vlans: 2
The following command displays detailed EAPS information:
show eaps detail
The results for a transit node are shown as follows:
EAPS Enabled: Yes
Number of EAPS instances: 1
EAPSD-Bridge links: 2
Name: “eaps1” (instance=0)
State: Links-Up [Running: Yes]
Enabled: Yes Mode: Transit
Failtimer expiry action: Displays the action taken when the failtimer expires:
• Send-alert—Sends a critical message to the syslog when the failtimer
expires.
• Open-secondary-port—Opens the secondary port when the failtimer
expires.
Displays only for master nodes.
Preforwarding Timer interval:
1
The configured value of the timer. This value is set internally by the EAPS
software.
Last update:
1
Displayed only for transit nodes; indicates the last time the transit node
received a hello packet from the master node (identified by its MAC address).
EAPS Domain has … Controller
Vlans:
Lists the assigned name and ID of the control VLAN.
EAPS Domain has … Protected
Vlans:
2
Lists the assigned names and VLAN IDs of all the protected VLANs
configured on this EAPS domain.
Number of Protected Vlans: The count of protected VLANs configured on this EAPS domain.
1. These fields apply only to transit nodes; they are not displayed for a master node.
2. This list is displayed when you use the detail keyword in the
show eaps
command.
To Next Page
Loading...