show inline-power info
ExtremeWare Software 7.3.0 Command Reference Guide 1927
Example
The following command displays summary inline power information for port 1:
show inline info port 1:*
Following is sample output from this command:
Port State Class Connect Volts Curr Res Power Fault
History (mA) (Kohms) (Watts)
1:1 searching ----- 0 0.0 0 0.0 0.00 0
The following command displays detail inline power information for port 1:
show inline info detail port 1:1
Following is sample output from this command:
Configured Admin State: Enabled
Inline Power State: searching
MIB Detect SStatus: searching
Lable:
Violation Precedence: max-class-operator
Operator Limit: 15400 milliwatts
Detection: auto
Reserved Power: 0 milliwatts
Inline Type: other
Connect Order: none
PD Class:
Max Allowed Power: 0.0 W
Measured Power: 0.0 W
Line Voltage: 0.0 Volts
Discovered Resistance: 0.0K ohms
Discovered Capacitance: 0 uF
Current: 0 mA
Fault Status: None
History
This command was first available in ExtremeWare 7.2.
Platform Availability
This command is available on Alpine series I/O modules only.
To Next Page
Loading...