show vlan
ExtremeWare Software 7.3.0 Command Reference Guide 349
Example
The following is an example of the
show vlan
command:
MSM64:1 # show vlan
Name VID Protocol Addr Flags Proto Ports
Default 1 0.0.0.0 /BP -----T-------- ANY 0/7
MacVlanDiscover 4095 ------------------ ------ ANY 0/0
Mgmt 4094 10.5.4.80 /24 -------------- ANY 1/1
pv1 4093 192.168.11.1 /24 ------f------- ANY 0/1
pv2 4092 192.168.12.1 /24 ------f------- ANY 0/1
pv3 4091 ------------------ ------ ANY 0/0
pv4 4090 ------------------ ------ ANY 0/0
Flags: (C) Domain-masterVlan, (c) Domain-memberVlan, (d) DVMRP Enabled
(E) ESRP Slave, (f) IP Forwarding Enabled, (G) GVRP Enabled
(i) ISIS Enabled, (I) IP Forwarding lpm-routing Enabled
(L) Loopback Enabled, (M) ESRP Master, (m) IPmc Forwarding Enabled
(N) GNS Reply Enabled, (o) OSPF Enabled, (P) IPX SAP Enabled
(p) PIM Enabled, (R) SubVLAN IP Range Configured, (r) RIP Enabled
(S) SuperVlan, (s) SubVlan, (T) Member of STP Domain
(v) VRRP Enabled, (X) IPX RIP Enabled
(2) IPX Type 20 Forwarding Enabled
Total number of Vlan(s) : 7
The following is an example of the
show vlan Default
command:
VLAN Interface[0-200] with name "Default" created by user
Tagging: 802.1Q Tag 1
Priority: 802.1P Priority 7
IP: 51.0.0.1/255.255.255.0
Sec.IP 53.0.0.1/255.255.255.0
STPD: s0(Disabled,Auto-bind)
Protocol: Match all unfiltered protocols.
Loopback: Disable
RateShape: Disable
QosProfile:QP1
QosIngress:None
Ports: 72. (Number of active ports=1)
Flags: (*) Active, (!) Disabled
(B) BcastDisabled, (R) RateLimited, (L) Loopback
(g) Load Share Group
Untag: *3:1 3:2 3:3 3:4 3:5 3:6 3:7 3:8
3:9 3:10 3:11 3:12 3:13 3:14 3:15 3:16
3:17 3:18 3:19 3:20 3:21 3:22 3:23 3:24
3:25 3:26 3:27 3:28 3:29 3:30 3:31 3:32
3:33 3:34 3:35 3:36 3:37 3:38 3:39 3:40
3:41 3:42 3:43 3:44 3:45 3:46 3:47 3:48
4:1 4:2 4:3 4:4 4:5 4:6 4:7 4:8
4:9 4:10 4:11 4:12 4:13 4:14 4:15 4:16
4:17 4:18 4:19 4:20 4:21 4:22 4:23 4:24
The following is an example of using the command to show a specific VLAN, v2, that contains a port
for a load-sharing group that spans multiple modules:
VLAN Interface[3-201] with name "v2" created by user
Tagging: 802.1Q Tag 2
To Next Page
Loading...