350 ExtremeWare Software 7.3.0 Command Reference Guide
VLAN Commands
Priority: 802.1P Priority 7
IP: 10.222.0.2/255.255.255.0
STPD: s0(Disabled,Auto-bind)
Protocol: Match all unfiltered protocols.
Loopback: Disable
RateShape: Disable
QosProfile:QP1
QosIngress:IQP1
Ports: 5. (Number of active ports=4)
Flags: * - Active, ! - Disabled
B - BcastDisabled, R - RateLimited, L - Loopback
(g) Load Share Group, (c) Cross Module Trunk
Untag: *1:25 5:10 5:25 7:25
Tagged: *5:4c
History
This command was first available in ExtremeWare 1.0.
This command was modified to support longer VLAN names in ExtremeWare 6.2.2.
This command was modified to include the Member of STP Domain flag in ExtremeWare 7.0.
This command was modified to support the
“3”
series modules in ExtremeWare 7.0.1.
This command was modified to include the cross-module trunk flag in ExtremeWare 7.1.1
The output of this command was changed to accommodate the multinetting feature by including
secondary IP addresses. This modified command was made available in ExtremeWare 7.3.0.
Platform Availability
This command is available on all platforms.
To Next Page
Loading...