C613-50631-01 Rev A Command Reference for IE340 Series 1001
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
ROUTING COMMANDS
IP
RESOLVE-VIA-DEFAULT
ip resolve-via-default
Overview Use this command to enable a routing protocol (most likely BGP) to use a default
route to resolve next hops.
This command affects recursive routes, which are routes where the next hop is
defined in terms of another IP address, and therefore resolving the next hop
requires another route lookup. Recursive routes are most common in BGP but can
occur in other routing protocols too.
Use the no variant of this command to stop the protocol from using a default route
to resolve next hops. This can be helpful when such use can lead to inappropriate
next hops being incorrectly activated.
Syntax
ip resolve-via-default
no ip resolve-via-default
Default Enabled
Mode Global Configuration
Usage notes This command's effect is not instantaneous. Changing this setting does not result
in an recalculation of all routes. Instead, the command will only result in changes
when routes are recalculated, or if you manually restart the routing protocol.
Example To stop the device from using default routes to resolve next hops, use the
commands:
awplus# configure terminal
awplus(config)# no ip resolve-via-default
To allow the device to use default routes to resolve next hops again, use the
commands:
awplus# configure terminal
awplus(config)# ip resolve-via-default
Related
commands
show ip resolve-via-default
Command
changes
Version 5.5.3-0.1: command added
To Next Page
Loading...
Need help?
General
