Allied Telesis IE340 Series - udld aggressive-mode

C613-50631-01 Rev A Command Reference for IE340 Series 775
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
UNIDIRECTIONAL LINK DETECTION (UDLD) COMMANDS
UDLD
AGGRESSIVE-MODE
udld aggressive-mode
Overview Use this command to set UDLD to aggressive mode on all interfaces.
In normal mode, when the UDLD information times out:
• No action is taken by UDLD.
• The UDLD port state is set to undetermined.
• The port behaves according to its STP state.
In aggressive mode, when the UDLD information times out:
• UDLD tries to re-establish the state of the port.
• If not successful, after 8 retries, the port is disabled.
Use the no variant of this command to disable aggressive mode on all interfaces.
Syntax
udld aggressive-mode
no udld aggressive-mode
Default Aggressive mode is disabled by default.
Mode Global Configuration
Example To enable aggressive mode on interfaces, use the commands:
awplus# configure terminal
awplus(config)# udld aggressive-mode
To disable aggressive mode, use the commands:
awplus# configure terminal
awplus(config)# no udld aggressive-mode
Related
commands
udld port aggressive-mode
show udld