59
C613-50631-01 Rev A Command Reference for IE340 Series 3109
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
DHCP for IPv6
(DHCPv6)
Commands
Introduction
Overview This chapter provides an alphabetical reference for commands used to configure
DHCPv6. For more information, see the DHCPv6 Feature Overview and
Configuration Guide.
DHCPv6 is a network protocol used to configure IPv6 hosts with IPv6 addresses and
IPv6 prefixes for an IPv6 network. DHCPv6 is used instead of SLAAC (Stateless
Address Autoconfiguration) at sites where centralized management of IPv6 hosts
is needed. IPv6 routers require automatic configuration of IPv6 addresses and IPv6
prefixes.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
NOTE: The IPv6 addresses shown use the address space 2001:0db8::/32, defined in RFC
3849 for documentation purposes. These addresses should not be used for practical
networks (other than for testing purposes) nor should they appear on any public
network.
Command List •“clear counter ipv6 dhcp-client” on page 3111
•“clear ipv6 dhcp client” on page 3112
•“ip dhcp-relay agent-option” on page 3113
•“ip dhcp-relay agent-option subscriber-id-auto-mac” on page 3115
•“ip dhcp-relay agent-option checking” on page 3116
•“ip dhcp-relay agent-option remote-id” on page 3117
•“ip dhcp-relay information policy” on page 3118
•“ip dhcp-relay maxhops” on page 3120
•“ip dhcp-relay max-message-length” on page 3121
•“ip dhcp-relay server-address” on page 3123
•“ipv6 address dhcp” on page 3125
To Next Page
Loading...
Need help?
General
