C613-50631-01 Rev A Command Reference for IE340 Series 338
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PLUGGABLES AND CABLING COMMANDS
FIBER
-MONITORING ENABLE
fiber-monitoring enable
Overview Use this command to enable active fiber monitoring on a fiber port. If the port can
support fiber monitoring but does not have the correct SFP or fiber type installed,
the configuration will be saved, and monitoring will commence when a supported
SFP is inserted. Disabling and re-enabling fiber monitoring on a port resets the
baseline calculation.
Use the no variants of this command to disable active fiber monitoring on the
interface, or to remove all the configuration and state for the ports, respectively.
Syntax
fiber-monitoring enable
no fiber-monitoring enable
no fiber-monitoring
Default Active fiber monitoring is disabled by default
Mode Interface Configuration mode for a fiber port
Examples To enable active fiber monitoring on port1.0.1 and port1.0.4, use the commands:
awplus(config)# interface port1.0.1-port1.0.4
awplus(config-if)# fiber-monitoring enable
To disable fiber monitoring on the ports, use the commands:
awplus(config)# interface port1.0.1-port1.0.4
awplus(config-if)# no fiber-monitoring enable
To remove all fiber-monitoring configuration and state for the ports, use the
commands:
awplus(config)# interface port1.0.1-port1.0.4
awplus(config-if)# no fiber-monitoring
Related
commands
fiber-monitoring action
fiber-monitoring sensitivity
show system fiber-monitoring
To Next Page
Loading...
Need help?
General
