C613-50631-01 Rev A Command Reference for IE340 Series 3217
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
LLDP COMMANDS
DEBUG
LLDP
debug lldp
Overview This command enables specific LLDP debug for specified ports. When LLDP
debugging is enabled, diagnostic messages are entered into the system log. If no
port list is supplied, the specified debugging is enabled for all ports.
The no variant of this command disables specific LLDP debug for specified ports. If
no port list is supplied, the specified debugging is disabled for all ports.
Syntax
debug lldp {[rx][rxpkt][tx][txpkt]} [interface [<port-list>]]
debug lldp operation
no debug lldp {[rx][rxpkt][tx][txpkt]} [interface
[<port-list>]]
no debug lldp operation
no debug lldp all
Default By default no debug is enabled for any ports.
Mode Privileged Exec
Examples To enable debugging of LLDP receive on ports 1.0.1 and 1.0.6, use the command:
awplus# debug lldp rx interface port1.0.1,port1.0.6
To enable debugging of LLDP transmit with packet dump on all ports, use the
command:
awplus# debug lldp tx txpkt
To disable debugging of LLDP receive on ports 1.0.1 and 1.0.6, use the command:
awplus# no debug lldp rx interface port1.0.1,port1.0.6
To turn off all LLDP debugging on all ports, use the command:
awplus# no debug lldp all
Parameter Description
rx LLDP receive debug.
rxpkt Raw LLDPDUs received in hex format.
tx LLDP transmit debug.
txpkt Raw Tx LLDPDUs transmitted in hex format.
<port-list> The ports for which debug is to be configured.
operation Debug for LLDP internal operation on the switch.
all Disables all LLDP debugging for all ports.
To Next Page
Loading...
Need help?
General
