C613-50631-01 Rev A Command Reference for IE340 Series 2869
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
ATMF
TOPOLOGY-GUI ENABLE
atmf topology-gui enable
Overview Use this command to enable the operation of Vista Manager EX on the Master
device.
Vista Manager EX delivers state-of-the-art monitoring and management for your
Autonomous Management Framework™ (AMF) network, by automatically creating
a complete topology map of switches, firewalls and wireless access points (APs).
An expanded view includes third-party devices such as security cameras.
Use the no variant of this command to disable operation of Vista Manager EX.
Syntax
atmf topology-gui enable
no atmf topology-gui enable
Default Disabled by default on AMF Master and member nodes. Enabled by default on
Controllers.
Mode Global Configuration mode
Usage notes To use Vista Manager EX, you must also enable the HTTP service on all AMF nodes,
including all AMF masters and controllers. The HTTP service is enabled by default
on AlliedWare Plus switches and disabled by default on AR-Series firewalls. To
enable it, use the commands:
Node1# configure terminal
Node1(config)# service http
On one master in each AMF area in your network, you also need to configure the
master to send event notifications to Vista Manager EX. To do this, use the
commands:
Node1# configure terminal
Node1(config)# log event-host <ip-address> atmf-topology-event
Examples To enable Vista Manager EX on Node1, use the commands:
Node1# configure terminal
Node1(config)# atmf topology-gui enable
To disable Vista Manager EX on Node1, use the commands:
Node1# configure terminal
Node1(config)# no atmf topology-gui enable
Related
commands
atmf enable
log event-host
service http
To Next Page
Loading...
Need help?
General
