C613-50631-01 Rev A Command Reference for IE340 Series 1771
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
MULTICAST COMMANDS
IPV
6 MULTICAST-ROUTING
ipv6 multicast-routing
Overview Use this command to turn on/off IPv6 multicast routing on the router; when turned
off the device does not perform multicast functions.
Use the no variant of this command to disable IPv6 multicast routing after
enabling it. Note the default stated below.
Syntax
ipv6 multicast-routing
no ipv6 multicast-routing
Default By default, IPv6 multicast routing is off.
Mode Global Configuration
Usage When the no variant of this command is used, the Multicast Routing Information
Base (MRIB) cleans up Multicast Routing Tables (MRT, and stops relaying multicast
forwarder events to multicast protocols.
When multicast routing is enabled, the MRIB starts processing any MRT
addition/deletion requests, and any multicast forwarding events.
You must enable multicast routing before issuing other multicast commands.
Examples
awplus# configure terminal
awplus(config)# ipv6 multicast-routing
awplus# configure terminal
awplus(config)# no ipv6 multicast-routing
Validation
Commands
show running-config
To Next Page
Loading...
Need help?
General
