C613-50631-01 Rev A Command Reference for IE340 Series 1046
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
RIP COMMANDS
IP
RIP SEND VERSION 1-COMPATIBLE
ip rip send version 1-compatible
Overview Use this command in Interface Configuration mode to send RIP version 1
compatible packets from a RIP version 2 interface to other RIP Interfaces. This
mechanism causes RIP version 2 interfaces to send broadcast packets instead of
multicasting packets, and is used in environments where multicast is not enabled
or where hosts do not listen to multicast.
Use the no variant of this command to use the setting specified by the version (RIP)
command, and disable the broadcast of RIP version 2 packets that are sent as
broadcast packets.
Syntax
ip rip send version 1-compatible
no ip rip send version
Default RIP version 2 is enabled by default.
Mode Interface Configuration for a VLAN interface.
Usage notes This command applies to a specific interface and overrides the version specified by
the version (RIP) command.
RIP can be run in version 1 compatible mode. Version 2 has more features than
version 1; in particular RIP version 2 supports authentication and classless routing.
Once the RIP version is set, RIP packets of that version will be received and sent on
all the RIP-enabled interfaces.
Use the ip rip send version command in an environment where you can send
multicast packets, for example, in environments where multicast is enabled and
where hosts listen to multicast.
Example To set the interface vlan2 to send RIP version 1- compatible packets, use the
commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip rip send version 1-compatible
Related
commands
ip rip send version
version (RIP)
Parameter Description
1-compatible Specify this parameter to send RIP version 1 compatible packets
from a version 2 RIP interface to other RIP interfaces.
This mechanism causes version 2 RIP interfaces to broadcast
packets instead of multicasting packets.
To Next Page
Loading...
Need help?
General
