C613-50631-01 Rev A Command Reference for IE340 Series 3369
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
TRIGGER COMMANDS
DESCRIPTION
(TRIGGER)
description (trigger)
Overview This command adds an optional description to help you identify the trigger. This
description is displayed in show command outputs and log messages.
The no variant of this command removes a trigger’s description. The show
command outputs and log messages stop displaying a description for this trigger.
Syntax
description <description>
no description
Mode Trigger Configuration
Examples To give trigger 240 the description daily status report, use the commands:
awplus# configure terminal
awplus(config)# trigger 240
awplus(config-trigger)# description daily status report
To remove the description from trigger 36, use the commands:
awplus# configure terminal
awplus(config)# trigger 36
awplus(config-trigger)# no description
Related
commands
show trigger
test
trigger
Parameter Description
<description> A word or phrase that uniquely identifies this trigger or its purpose.
Valid characters are any printable character and spaces, up to a
maximum of 40 characters.
To Next Page
Loading...
Need help?
General
