C613-50631-01 Rev A Command Reference for IE340 Series 141
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
FILE AND CONFIGURATION MANAGEMENT COMMANDS
AUTOBOOT
ENABLE
autoboot enable
Overview This command enables the device to restore a release file and/or a configuration
file from a USB storage device.
When the Autoboot feature is enabled, the device looks for a special file called
autoboot.txt on the external media. If this file exists, the device will check the key
and values in the file and recover the device with a new release file and/or
configuration file from the external media. An example of a valid autoboot.txt file
is shown in the following figure.
Figure 3-1: Example autoboot.txt file
Use the no variant of this command to disable the Autoboot feature.
Syntax
autoboot enable
no autoboot enable
Default The Autoboot feature operates the first time the device is powered up in the field,
after which the feature is disabled by default.
Mode Global Configuration
Example To enable the Autoboot feature, use the command:
awplus# configure terminal
awplus(config)# autoboot enable
Related
commands
create autoboot
show autoboot
show boot
[AlliedWare Plus]ď€
Copy_from_external_media_enabled=yesď€
Boot_Release=IE340-5.5.3-0.1.relď€
Boot_Config=network1.cfg
To Next Page
Loading...
Need help?
General
