Allied Telesis IE340 Series - show debugging udld

C613-50631-01 Rev A Command Reference for IE340 Series 771
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
UNIDIRECTIONAL LINK DETECTION (UDLD) COMMANDS
SHOW
DEBUGGING UDLD
show debugging udld
Overview Use this command to show which UDLD debugging options are set.
Syntax
show debugging udld
Mode Privileged Exec
Example To show which UDLD debugging options are set, use the command:
awplus# show debugging udld
Output Figure 18-1: Example output from show debugging udld
Related
commands
debug udld
awplus# show debugging udld
UDLD debugging status:
Info debugging : off
Packet debugging: off
State debugging : on
NSM debugging : off