C613-50631-01 Rev A Command Reference for IE340 Series 2790
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
ATMF
AMFPLUS-LICENSE-ONLY
atmf amfplus-license-only
Overview Use this command if you want to use the AMF Plus features in Vista Manager EX,
and you have a mixture of AMF and AMF Plus licenses on your master node. This
command sets the AMF network to only count AMF Plus licensed nodes.
Use the no variant of this command to include both AMF and AMF Plus licenses
when calculating the number of licensed nodes in an area count.
Syntax
atmf amfplus-license-only
no atmf amfplus-license-only
Default The no version is the default. That is, consider both AMF and AMF Plus licenses
when calculating the number of licensed nodes.
Mode Global Configuration
Usage notes From software version 5.5.2-2.3 onwards, AMF licenses are no longer available to
purchase. Instead, AMF Plus licenses become available. Existing AMF licenses
remain valid. You only need to change to AMF Plus licenses if you want to manage
more nodes, or use the new AMF Plus menu in Vista Manager.
CAUTION: If the network has more AMF nodes than are licensed with AMF Plus:
• AMF Plus will still be enabled in Vista Manager EX (provided there is no AMF
license)
• any AMF nodes above the license count won’t join the AMF network.
The AMF Plus menu replaces the AOI menu in Vista Manager EX when all the AMF
Masters and Controllers have:
• An AMF Plus Controller/Master license on all Masters and Controllers, and
• No AMF Controller/Master licenses applied, or AMF Controller/Master
licenses disabled with this command.
Example To set the AMF network to only count AMF Plus licensed nodes, use the
commands:
awplus#configure terminal
awplus(config)#atmf amfplus-license-only
To Next Page
Loading...
Need help?
General
