C613-50631-01 Rev A Command Reference for IE340 Series 781
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
UNIDIRECTIONAL LINK DETECTION (UDLD) COMMANDS
UDLD
TIME DISABLE-PERIOD
udld time disable-period
Overview Use this command to set the UDLD disable period on all interfaces. The disable
period is the time (in seconds) that a port is marked disabled before UDLD
attempts to recheck it.
Manually reset the UDLD status of a port using the udld reset command.
Use the no variant of this command to reset the disable period to infinite.
Syntax
udld time disable-period <seconds>
no udld time disable-period
Default The default time disable period is infinite.
Mode Global Configuration
Example To change the UDLD disable period to 60 sec on all interfaces, use the commands:
awplus# configure terminal
awplus(config)# udld time disable-period 60
To reset the disable period to infinite, use the commands:
awplus# configure terminal
awplus(config)# no udld time disable-period
Related
commands
udld enable
udld port
show udld
Parameter Description
<seconds> 30-86400 ď€
Specify the disable period in seconds.
To Next Page
Loading...
Need help?
General
