C613-50631-01 Rev A Command Reference for IE340 Series 1749
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
MULTICAST COMMANDS
CLEAR
IPV6 MROUTE
clear ipv6 mroute
Overview Use this command to delete one or more dynamically-added route entries from
the IPv6 multicast routing table.
You need to do this, for example, if you want to create a static route instead of an
existing dynamic route.
Syntax
clear ipv6 mroute {*|<ipv6-group-address>
[<ipv6-source-address>]}
Mode Privileged Exec
Usage notes When this command is used, the Multicast Routing Information Base (MRIB) clears
the relevant IPv6 multicast route entries in its IPv6 multicast route table, and
removes the entries from the multicast forwarder. The MRIB sends a “clear”
message to the multicast protocols. Each multicast protocol has its own “clear”
multicast route command.
This command does not remove static routes from the routing table or the
configuration. To remove static routes, use the no parameter of the command ipv6
multicast route.
Example
awplus# clear ipv6 mroute 2001::2 ff08::1
Related
commands
ipv6 multicast route
show ipv6 mroute
Parameter Description
* Deletes all dynamically-learned IPv6 multicast routes.
<ipv6-group-address> Group IPv6 address, in hexadecimal notation in the
format X.X::X.X.
<ipv6-source-address> Source IPv6 address, in hexadecimal notation in the
format X.X::X.X.
To Next Page
Loading...
Need help?
General
