68
C613-50631-01 Rev A Command Reference for IE340 Series 3403
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Ping-Polling
Commands
Introduction
Overview This chapter provides an alphabetical reference for commands used to configure
Ping Polling. For more information, see the Ping Polling Feature Overview and
Configuration Guide.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Command List •“active (ping-polling)” on page 3405
•“clear ping-poll” on page 3406
•“critical-interval” on page 3407
•“debug ping-poll” on page 3408
Table 68-1: The following table lists the default values when configuring a ping
poll
Default Value
Critical-interval 1 second
Description No description
Fail-count 5
Length 32 bytes
Normal-interval 30 seconds
Sample-size 5
Source-ip The IP address of the interface from which the ping packets are
transmitted
Time-out 1 second
Up-count 30
To Next Page
Loading...
Need help?
General
