Allied Telesis IE340 Series - active (ping-polling)

C613-50631-01 Rev A Command Reference for IE340 Series 3405
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PING-POLLING COMMANDS
ACTIVE
(PING-POLLING)
active (ping-polling)
Overview This command enables a ping-poll instance. The polling instance sends ICMP echo
requests to the device with the IP address specified by the ip (ping-polling)
command.
By default, polling instances are disabled. When a polling instance is enabled, it
assumes that the device it is polling is unreachable.
The no variant of this command disables a ping-poll instance. The polling instance
no longer sends ICMP echo requests to the polled device. This also resets all
counters for this polling instance.
Syntax
active
no active
Mode Ping-Polling Configuration
Examples To activate the ping-poll instance 43, use the commands:
awplus# configure terminal
awplus(config)# ping-poll 43
awplus(config-ping-poll)# active
To disable the ping-poll instance 43 and reset its counters, use the commands:
awplus# configure terminal
awplus(config)# ping-poll 43
awplus(config-ping-poll)# no active
Related
commands
debug ping-poll
ip (ping-polling)
ping-poll
show ping-poll