Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 825
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
POWER OVER ETHERNET COMMANDS
SHOW
DEBUGGING POWER-INLINE
show debugging power-inline
Overview This command displays Power over Ethernet (PoE) debug settings.
Syntax
show debugging power-inline
Mode User Exec and Privileged Exec
Example To display PoE debug settings, use the following command:
awplus# show debugging power-inline
Output Figure 20-1: Example output from the show debugging power-inline
command
Related
commands
debug power-inline
terminal monitor
Command
changes
Version 5.4.8-0.2: added to x550 series products
awplus#show debugging power-inline
PoE Debugging status:
PoE Informational debugging is disabled
PoE Event debugging is disabled
PoE Power Management debugging is disabled

PoE NSM debugging is enabled

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English