C613-50631-01 Rev A Command Reference for IE340 Series 3245
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
LLDP COMMANDS
LOCATION
COORD-LOCATION IDENTIFIER
location coord-location identifier
Overview Use this command to enter Coordinate Location Configuration mode for this
coordinate location.
Use the no variant of this command to delete a coordinate location. This also
removes the location from any ports it has been assigned to.
Syntax
location coord-location identifier <coord-loc-id>
no location coord-location identifier <coord-loc-id>
Default By default there are no coordinate locations.
Mode Global Configuration
Usage Up to 400 locations can be configured on the switch for each type of location
information, up to a total of 1200 locations.
To configure this coordinate location, use the location coord-location
configuration command. To associate this coordinate location with particular
ports, so that it can be advertised in TLVs from those ports, use the location
coord-location-id command.
Examples To enter Coordinate Location Configuration mode to configure the coordinate
location with ID 1, use the commands:
awplus# configure terminal
awplus(config)# location coord-location identifier 1
awplus(config-coord)#
To delete coordinate location 1, use the commands:
awplus# configure terminal
awplus(config)# no location coord-location identifier 1
Related
commands
location coord-location-id
location coord-location configuration
show lldp local-info
show location
Parameter Description
<coord-loc-id> A unique coordinate location identifier, in the range 1 to
4095.
To Next Page
Loading...
Need help?
General
