Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 3410
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PING-POLLING COMMANDS
FAIL
-COUNT
fail-count
Overview This command specifies the number of pings that must be unanswered, within the
total number of pings specified by the sample-size command, for the ping-polling
instance to consider the device unreachable.
If the number set by the sample-size command and the fail-count commands are
the same, then the unanswered pings must be consecutive. If the number set by
the sample-size command is greater than the number set by the fail-count
command, then a device that does not always reply to pings may be declared
unreachable.
The no variant of this command resets the fail count to the default.
Syntax
fail-count <1-100>
no fail-count
Default The default is 5.
Mode Ping-Polling Configuration
Examples To specify the number of pings that must fail within the sample size to determine
that a device is unreachable for ping-polling instance 45, use the commands:
awplus# configure terminal
awplus(config)# ping-poll 45
awplus(config-ping-poll)# fail-count 5
To reset the fail-count to its default of 5 for ping-polling instance 45, use the
commands:
awplus# configure terminal
awplus(config)# ping-poll 45
awplus(config-ping-poll)# no fail-count
Related
commands
critical-interval
normal-interval
ping-poll
sample-size
show ping-poll
timeout (ping polling)
up-count
Parameter Description
<1-100> The number of pings within the sample size that a reachable device
must fail to respond to before it is classified as unreachable.

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English