C613-50631-01 Rev A Command Reference for IE340 Series 3464
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
MODBUS COMMANDS
CLEAR
SCADA MODBUS TCP SERVER CONNECTION
clear scada modbus tcp server connection
Overview Use this command to forcefully disconnect a MODBUS client that is currently
connected to the MODBUS TCP server.
Syntax
clear scada modbus tcp server connection <ip-address> <1-65535>
Mode Privileged Exec
Example To forcefully disconnect a client from the MODBUS TCP server, use the following
commands:
awplus# configure terminal
awplus(config)# clear scada modbus tcp server connection
198.51.100.200 33229
Related
commands
scada modbus tcp server port
scada modbus tcp server connection
show scada modbus tcp server
scada modbus tcp server access
clear scada modbus tcp server statistics
show scada modbus tcp server connections
Command
changes
Version 5.4.8-2.1: command added
Version 5.4.9-0.1: MODBUS support added for x930, x950 series
Version 5.5.0-1.1: MODBUS support added for IE510 series
Parameter Description
<ip-address> The IPv4 or IPv6 address of the MODBUS TCP server.
<1-65535> The port ID number.
To Next Page
Loading...
Need help?
General
