C613-50631-01 Rev A Command Reference for IE340 Series 2705
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
G.8032 ETHERNET RING PROTECTION SWITCHING COMMANDS
DATA
-TRAFFIC
data-traffic
Overview Use this command to add a data traffic VLAN or a range of VLANs to be protected
by this G.8032 Ethernet Ring Protection (ERP) instance.
Use the no variant of this command to remove a data traffic VLAN or a range of
VLANs.
Syntax
data-traffic <vid-list>
no data-traffic <vid-list>
Mode G8032 Configure Switch
Usage notes • A G.8032 ERP instance can protect 0, 1 or more VLANs carrying data traffic.
• This ERP instance must be associated with a physical ring instance.
• Other ERP instances using the same physical ring instance are not allowed to
have the same data traffic VLAN(s) as this ERP instance.
• The data VLAN(s) must already exist.
• The data VLAN(s)’ port members should be members of the ring interface(s),
but it is not enforced.
• When a data traffic VLAN(s) is removed, any blocks that were in place on the
ring ports for this VLAN(s) are removed. The user should make sure when
removing the VLAN(s) from the ERP instance that a loop is not formed.
• Data traffic VLAN(s) can be added or removed while the ERP instance is
enabled or disabled.
Example To add a data traffic VLAN with a VLAN ID of “103” to an ERP instance named “blue”,
use the following commands:
awplus(config)# g8032 erp-instance blue
awplus(g8032-config-switch)# data-traffic 103
Related
commands
g8032 erp-instance
show g8032 erp-instance
Command
changes
Version 5.4.7-0.1: command added
Version 5.4.7-1.1: added to x310 series products
Version 5.4.7-2.1: added to x550 series products
Parameter Description
<vid-list> The data traffic VLAN ID(s). This can be a single VLAN ID, or can be
a range of VLAN IDs separated by hyphen, or a comma separated
list of VLAN IDs and ranges. Each VLAN ID can take on the range of
1 to 4094
To Next Page
Loading...
Need help?
General
