C613-50631-01 Rev A Command Reference for IE340 Series 790
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
LINK AGGREGATION COMMANDS
LACP
GLOBAL-PASSIVE-MODE ENABLE
lacp global-passive-mode enable
Overview Use this command to enable LACP channel-groups to dynamically self-configure
when they are connected to another device that has LACP channel-groups
configured with Active Mode.
Syntax
lacp global-passive-mode enable
no lacp global-passive-mode enable
Default Enabled
Mode Global Configuration
Usage notes Do not mix LACP configurations (manual and dynamic). When LACP global passive
mode is turned on (by using the lacp global-passive-mode enable command),
we do not recommend using a mixed configuration in a LACP channel-group; i.e.
some links are manually configured (by the channel-group command) and others
are dynamically learned in the same channel-group.
Example To enable global passive mode for LACP channel groups, use the command:
awplus(config)# lacp global-passive-mode enable
To disable global passive mode for LACP channel groups, use the command:
awplus(config)# no lacp global-passive-mode enable
Related
commands
show etherchannel
show etherchannel detail
To Next Page
Loading...
Need help?
General
