C613-50631-01 Rev A Command Reference for IE340 Series 1799
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SM COMMANDS
IP
PIM CISCO-REGISTER-CHECKSUM
ip pim cisco-register-checksum
Overview Use this command to configure the option to calculate the Register checksum over
the whole packet. This command is used to inter-operate with older Cisco IOS
versions.
Use the no variant of this command to disable this option.
Syntax
ip pim cisco-register-checksum
no ip pim cisco-register-checksum
Default This command is disabled by default. By default, Register Checksum is calculated
only over the header.
Mode Global Configuration
Example
awplus# configure terminal
awplus(config)# ip pim cisco-register-checksum
Command
changes
Version 5.4.7-1.1: VRF-lite support added SBx8100.
Version 5.4.8-1.1: VRF-lite support added x930, SBx908 GEN2.
To Next Page
Loading...
Need help?
General
