C613-50631-01 Rev A Command Reference for IE340 Series 444
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
LOGGING COMMANDS
LOG
EXTERNAL (FILTER)
log external (filter)
Overview Use this command to create a filter to select messages to be sent to the external
log. You can include messages based on:
• the priority/severity of the message
• the program that generated the message
• the logging facility used
• a sub-string within the message, or
• a combination of some or all of these.
The no variant of this command removes the corresponding filter, so that the
specified messages are no longer sent to the external log.
Syntax
log external [level <level>] [program <program-name>] [facility
<facility>] [msgtext <text-string>]
no log external [level <level>] [program <program-name>]
[facility <facility>] [msgtext <text-string>]
Parameter Description
level Filter messages to the external log by severity level.
<level> The minimum severity of message to send to the external log. The level can be specified as
one of the following numbers or level names, where 0 is the highest severity and 7 is the
lowest severity:
0|emergencies System is unusable
1|alerts Action must be taken immediately
2|critical Critical conditions
3|errors Error conditions
4|warnings Warning conditions
5|notices Normal, but significant, conditions
6|informational Informational messages
7|debugging Debug-level messages
program Filter messages to the external log by program. Include messages from a specified program in
the external log.
<program-
name>
The name of a program to log messages from. You can enter either one of the following
predefined program names (depending on your device model), or another program name
that you find in the log output. The pre-defined names are not case sensitive but other
program names from the log output are.
rip Routing Information Protocol (RIP)
ripng Routing Information Protocol - next generation (RIPng)
ospf Open Shortest Path First (OSPF)
To Next Page
Loading...
Need help?
General
