C613-50631-01 Rev A Command Reference for IE340 Series 1885
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SMV6 COMMANDS
IPV
6 PIM UNICAST-BSM
ipv6 pim unicast-bsm
Overview Use this command to enable support for the sending and receiving of unicast Boot
Strap Messages (BSM) on an interface.
Use the no variant of this command to disable the sending and receiving of unicast
BSM on an interface.
Syntax
ipv6 pim unicast-bsm
no ipv6 pim unicast-bsm
Mode Interface Configuration for a VLAN interface.
Default Unicast BSM is disabled by default on an interface.
Usage This command provides backward compatibility with older versions of the Boot
Strap Router (BSR) specification, which directs unicast BSM to refresh the state of
new or restarting neighbors. The current BSR specification defines a No Forward
BSM to achieve the same result.
Examples To enable BSM messages on vlan2, use the commands:
awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# interface vlan2
awplus(config-if)# ipv6 enable
awplus(config-if)# ipv6 pim unicast-bsm
To disable BSM messages on vlan2, use the commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# no ipv6 pim unicast-bsm
To Next Page
Loading...
Need help?
General
