C613-50631-01 Rev A Command Reference for IE340 Series 3069
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP) COMMANDS
IP
DHCP-RELAY USE-CLIENT-SIDE-ADDRESS
ip dhcp-relay use-client-side-address
Overview Use this command to configure DHCP-Relay to use the client-side interface (that is
the interface receiving the DHCP client packets) IP address as the source address of
the relayed DHCP packets.
Use the no variant of this command to disable the use of the client-side interface
IP address as the source IP address for relayed DHCP packets.
Syntax
ip dhcp-relay use-client-side-address
no ip dhcp-relay use-client-side-address
Default By default, the server-side interface IP address is used as the source IP address of
DHCP relayed packets.
Mode Global Configuration
Usage notes In most cases, there are filters placed between the DHCP relay and DHCP server
which only allow DHCP packets from the client subnet to the server and back. This
command allows you to configure the DHCP relay so that the relay will use the IP
address of the interface receiving clients’ DHCP requests to be used as the source
IP address of the relayed DHCP packets.
Example To configure the client-side IP address as the source IP address of DHCP relayed
packets, use the following commands:
awplus# configure terminal
awplus(config)# ip dhcp-relay use-client-side-address
Output Figure 58-3: Example output from show ip dhcp-relay
The second line of the display output shows the status of the client-side address
being enabled as the source IP address.
Related
commands
ip dhcp-relay server-address
Command
changes
Version 5.4.9-0.7: command added
Parameter Description
use-client-side-address Use the client side interface IP address as the
source IP address for relayed DHCP packets.
awplus#sh ip dhcp-relayď€
ď€
DHCP Relay Service is enabledď€
Use of client side address as source address is enabledď€
...
To Next Page
Loading...
Need help?
General
