To Next Page

To Previous Page

C613-50631-01 Rev A Command Reference for IE340 Series 2971

AlliedWare Plus™ Operating System - Version 5.5.3-0.x

AMF AND AMF PLUS COMMANDS

SHOW

ATMF GUESTS DETAIL

show atmf guests detail

Overview This command is available on any AMF master in the network. It displays details

about the AMF guest nodes that exist in the AMF network, such as device type, IP

address, MAC address etc.

Syntax

show atmf guests detail [<node-name>] [<guest-port>]

Mode User Exec/Privileged Exec

Usage notes If you want to see only the guests attached to a single node, you can use either:

• this command and specify the node name, or

• show atmf links guest detail, which shows information about the guest

nodes and also about their link to their parent node.

Note that the parameters that are displayed depend on the guest node’s model.

Example To display the AMF guest output, use the command:

awplus# show atmf guests detail

Output Figure 57-25: Example output from show atmf guests detail

Parameter Description

<node-name> The name of the guest node’s parent.

<guest-port> The port name on the parent node.

master#show atmf guests detail



ATMF Guest Node Information:



Node Name : master

Port Name : port1.0.9

Ifindex : 5009

Guest Description : red-1.0.9

Device Type : x600-24Ts

Backup Supported : No

MAC Address : 0000.cd38.0c4d

IP Address : 192.168.1.5

IPv6 Address : Not Set

HTTP Port : 0

Firmware Version : 5.4.2-0.1

Allied Telesis IE340 Series User Manual

Other manuals for Allied Telesis IE340 Series