Allied Telesis IE340 Series User Manual

C613-50631-01 Rev A Command Reference for IE340 Series 2963
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
SHOW
ATMF DETAIL
show atmf detail
Overview This command displays details about an AMF node. It can only be run on AMF
master and controller nodes.
Syntax
show atmf detail
Mode Privileged Exec
Example 1 To display the AMF node1 information in detail, use the command:
controller-1# show atmf detail
A typical output screen from this command is shown below:
Parameter Description
detail Displays output in greater depth.
atmf-1#show atmf detail 
ATMF Detail Information: 

Network Name : Test_network 
Network Mtu : 1300
Node Name : controller-1 
Node Address : controller-1.atmf 
Node ID : 342 
Node Depth : 0 
Domain State : BackupDomainController
Recovery State : None 
Recovery Over ETH Ports : Disabled
Log Verbose Setting : Verbose
Topology GUI : Disabled

Management VLAN 
VLAN ID : 4000 
Management Subnet : 172.31.0.0 
Management IP Address : 172.31.1.86
Management Mask : 255.255.128.0 
Management IPv6 Address : fd00:4154:4d46:1::156
Management IPv6 Prefix Length : 64

Domain VLAN 
VLAN ID : 4091
Domain Subnet : 172.31.128.0
Domain IP Address : 172.31.129.86
Domain Mask : 255.255.128.0

Allied Telesis IE340 Series Specifications

General

Brand	Allied Telesis
Model	IE340 Series
Category	Switch
Language	English