C613-50631-01 Rev A Command Reference for IE340 Series 1908
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-DM COMMANDS
DEBUG
PIM DENSE-MODE ALL
debug pim dense-mode all
Overview This command enables PIM-DM debugging.
The no variant of this command disables PIM-DM debugging.
Syntax
debug pim dense-mode all
no debug pim dense-mode all
Mode Privileged Exec and Global Configuration
Example
awplus# configure terminal
awplus(config)# debug pim dense-mode all
Output Figure 37-1: Example output from the debug pim dense-mode all command
Validation
Commands
show debugging pim dense-mode
Related
commands
debug pim dense-mode context
debug pim dense-mode decode
debug pim dense-mode encode
debug pim dense-mode fsm
debug pim dense-mode mrt
debug pim dense-mode nexthop
debug pim dense-mode nsm
debug pim dense-mode vif
PIM event debugging is onď€
ď€
PIM MFC debugging is onď€
ď€
PIM state debugging is onď€
ď€
PIM packet debugging is onď€
ď€
PIM incoming packet debugging is onď€
ď€
PIM outgoing packet debugging is onď€
To Next Page
Loading...
Need help?
General
