Allied Telesis IE340 Series - ip pim exclude-genid

C613-50631-01 Rev A Command Reference for IE340 Series 1803
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SM COMMANDS
IP
PIM EXCLUDE-GENID
ip pim exclude-genid
Overview Use this command to exclude the GenID option from Hello packets sent out by the
PIM module on a particular interface.This command is used to inter-operate with
older Cisco IOS versions.
Use the no variant of this command to revert to default settings.
Syntax
ip pim exclude-genid
no ip pim exclude-genid
Default By default, this command is disabled; the GenID option is included.
Mode Interface Configuration for a VLAN interface.
Example To exclude the GenID option on interface vlan2, use the following commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip pim exclude-genid