C613-50631-01 Rev A Command Reference for IE340 Series 1801
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SM COMMANDS
IP
PIM CRP-CISCO-PREFIX
ip pim crp-cisco-prefix
Overview Use this command to interoperate with Cisco devices that conform to an earlier
draft standard. Some Cisco devices might not accept candidate RPs with a group
prefix number of zero. Note that the latest BSR specification prohibits sending RP
advertisements with prefix 0. RP advertisements for the default IPv4 multicast
group range 224/4 are sent with a prefix of 1.
Use the no variant of this command to revert to the default settings.
Syntax
ip pim crp-cisco-prefix
no ip pim crp-cisco-prefix
Mode Global Configuration
Example
awplus# configure terminal
awplus(config)# ip pim crp-cisco-prefix
awplus# configure terminal
awplus(config)# no ip pim crp-cisco-prefix
Related
commands
ip pim rp-candidate
Command
changes
Version 5.4.7-1.1: VRF-lite support added SBx8100.
Version 5.4.8-1.1: VRF-lite support added x930, SBx908 GEN2.
To Next Page
Loading...
Need help?
General
