C613-50631-01 Rev A Command Reference for IE340 Series 1239
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
OSPFV3 FOR IPV6 COMMANDS
DEBUG
IPV6 OSPF ROUTE
debug ipv6 ospf route
Overview This command enables debugging of route calculation. Use this command
without parameters to turn on all the options.
The no and undebug variants of this command disable IPv6 OSPF route
debugging. Use this command without parameters to disable all options.
Syntax
debug ipv6 ospf route [ase] [ia] [install] [spf]
no debug ipv6 ospf route [ase] [ia] [install] [spf]
Mode Privileged Exec and Global Configuration
Examples To enable IPv6 route debugging of inter-area route calculations, use the following
command:
awplus# debug ipv6 ospf route ia
Related
commands
terminal monitor
undebug ipv6 ospf route
Parameter Description
ase Specifies the debugging of external route calculation.
ia Specifies the debugging of inter-area route calculation.
install Specifies the debugging of route installation.
spf Specifies the debugging of SPF calculation.
To Next Page
Loading...
Need help?
General
