C613-50631-01 Rev A Command Reference for IE340 Series 3248
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
LLDP COMMANDS
LOCATION
ELIN-LOCATION
location elin-location
Overview Use this command to create or modify an ELIN location.
Use the no variant of this command to delete an ELIN location, and remove it from
any ports it has been assigned to.
Syntax
location elin-location <elin> identifier <elin-loc-id>
no location elin-location identifier <elin-loc-id>
Default By default there are no ELIN location identifiers.
Mode Global Configuration
Usage Up to 400 locations can be configured on the switch for each type of location
information, up to a total of 1200 locations.
To assign this ELIN location to particular ports, so that it can be advertised in TLVs
from those ports, use the location elin-location-id command.
Examples To create a new ELIN location with ID 1, and configure it with ELIN "1234567890",
use the commands:
awplus# configure terminal
awplus(config)# location elin-location 1234567890 identifier 1
To delete existing ELIN location with ID 1, use the commands:
awplus# configure terminal
awplus(config)# no location elin-location identifier 1
Related
commands
location elin-location-id
show lldp local-info
show location
Parameter Description
<elin> Emergency Location Identification Number (ELIN) for
Emergency Call Service (ECS), in the range 10 to 25 digits long. In
North America, ELINs are typically 10 digits long.
<elin-loc-id> A unique ELIN location identifier, in the range 1 to 4095.
To Next Page
Loading...
Need help?
General
