C613-50631-01 Rev A Command Reference for IE340 Series 2184
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
802.1X COMMANDS
DOT
1X KEYTRANSMIT
dot1x keytransmit
Overview Use this command to enable key transmission on the interface specified previously
in Interface mode.
This command enables key transmission over an Extensible Authentication
Protocol (EAP) packet between the authenticator and supplicant.
The no variant of this command disables key transmission on the interface
specified.
Syntax
dot1x keytransmit
no dot1x keytransmit
Default Key transmission for port authentication is disabled by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
Examples To enable the key transmit feature on interface port1.0.2, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# dot1x keytransmit
To disable the key transmit feature on interface port1.0.2, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no dot1x keytransmit
Related
commands
show dot1x
show dot1x interface
Command
changes
Version 5.4.9-2.1: command added to AR2050V, AR3050S, and AR4050S
To Next Page
Loading...
Need help?
General
