C613-50631-01 Rev A Command Reference for IE340 Series 1764
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
MULTICAST COMMANDS
IP
MULTICAST-ROUTING
ip multicast-routing
Overview Use this command to turn on/off IPv4 multicast routing on the router; when turned
off the device does not perform multicast functions.
Use the no variant of this command to disable IPv4 multicast routing after
enabling it. Note the default stated below.
Syntax
ip multicast-routing
no ip multicast-routing
Default By default, IPv4 multicast routing is off.
Mode Global Configuration
Usage notes When the no variant of this command is used, the Multicast Routing Information
Base (MRIB) cleans up Multicast Routing Tables (MRT), stops IGMP operation, and
stops relaying multicast forwarder events to multicast protocols.
When multicast routing is enabled, the MRIB starts processing any MRT
addition/deletion requests, and any multicast forwarding events.
You must enable multicast routing before issuing other multicast commands.
Example
awplus# configure terminal
awplus(config)# ip multicast-routing
Validation
Commands
show running-config
Command
changes
Version 5.4.7-1.1: VRF-lite support added SBx8100.
Version 5.4.8-1.1: VRF-lite support added x930, SBx908 GEN2.
To Next Page
Loading...
Need help?
General
