Allied Telesis IE340 Series - application-proxy quarantine-vlan

C613-50631-01 Rev A Command Reference for IE340 Series 2774
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AMF AND AMF PLUS COMMANDS
APPLICATION
-PROXY QUARANTINE-VLAN
application-proxy quarantine-vlan
Overview Use this command to set the quarantine VLAN to use when an AMF Security
(AMF-Sec) Controller detects a threat. The port/s on which the threat is detected
are moved to this VLAN if the application-proxy threat-protection action is set to
quarantine.
Use the no variant of this command to delete the quarantine VLAN. If no
quarantine VLAN is specified then no quarantine action will be performed.
Syntax
application-proxy quarantine-vlan <vlan-id>
no application-proxy quarantine-vlan
Default By default, no quarantine VLAN is configured.
Mode Global Configuration
Example To configure VLAN 100 as the quarantine VLAN, use the commands:
awplus# configure terminal
awplus(config)# application-proxy quarantine-vlan 100
To delete the quarantine VLAN, use the commands:
awplus# configure terminal
awplus(config)# no application-proxy quarantine-vlan
Related
commands
application-proxy threat-protection
clear application-proxy threat-protection
application-proxy threat-protection send-summary
service atmf-application-proxy
show application-proxy threat-protection
Command
changes
Version 5.4.7-2.2: command added
Parameter Description
<vlan-id>
The ID of the VLAN to use. In the range 1-4094.