Allied Telesis IE340 Series - auth timeout server-timeout

C613-50631-01 Rev A Command Reference for IE340 Series 2254
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
AUTHENTICATION COMMANDS
AUTH
TIMEOUT SERVER-TIMEOUT
auth timeout server-timeout
Overview Use this command to set the timeout for the waiting response from the RADIUS
server on a given interface.
Use the no variant of this command to reset the server-timeout to the default (30
seconds).
Syntax
auth timeout server-timeout <1-65535>
no auth timeout server-timeout
Default The server timeout for port authentication is 30 seconds.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
Examples To set the server timeout to 120 seconds for interface port1.0.2, use the following
commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# auth timeout server-timeout 120
To set the server timeout to the default (30 seconds) for interface port1.0.2 use the
following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no auth timeout server-timeout
To set the server timeout to 120 seconds for authentication profile ‘student’, use
the commands:
awplus# configure terminal
awplus(config)# auth profile student
awplus(config-auth-profile)# auth timeout server-timeout 120
To set the server timeout to the default (30 seconds) for authentication profile
‘student’, use the commands:
awplus# configure terminal
awplus(config)# auth profile student
awplus(config-auth-profile)# no auth timeout server-timeout
Related
commands
auth profile (global)
Parameter Description
<1-65535> Server timeout period (in seconds).