C613-50631-01 Rev A Command Reference for IE340 Series 279
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
FINDME
TRIGGER
findme trigger
Overview When this command is enabled, the LED flashing functionality of the find-me
command is applied whenever any or all of the selected parameter conditions is
detected.
Use the no variant to remove the findme trigger function for the selected
parameter.
Syntax
findme trigger {all|loopprot|thrash-limit|qsp}
no findme trigger {all|loopprot|thrash-limit|qsp}
Default The findme trigger function is disabled.
Mode Global config
Usage notes Note that findme trigger is not available if you have set the switch to take the
following actions in response to an event:
• For loop detection, the actions log-only and none
• For MAC address thrash-limiting, the actions learn-disable and none.
Example To enable action LED flashing for the loop protection function:
awplus# findme trigger loopprot
Related
commands
findme
loop-protection loop-detect
storm-protection
Parameter Description
all Enable the find-me function whenever any of the listed parameter
conditions are detected
loopprot Enable the findme function whenever a loop protection condition
is detected.
thrash-limit Enable the findme function whenever a MAC address
thrash-limiting condition is detected.
qsp Enable the findme function whenever a QoS Storm Protection
condition is detected.
To Next Page
Loading...
Need help?
General
