C613-50631-01 Rev A Command Reference for IE340 Series 1812
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
PIM-SM COMMANDS
IP
PIM REGISTER-SOURCE
ip pim register-source
Overview Use this command to configure the source address of register packets sent by this
DR, overriding the default source address, which is the address of the RPF interface
toward the source host.
Use the no variant of this command to un-configure the source address of Register
packets sent by this DR, reverting back to use the default source address that is the
address of the RPF interface toward the source host.
Syntax
ip pim register-source [<source-address>|<interface>]
no ip pim register-source
Usage notes The configured address must be a reachable address to be used by the RP to send
corresponding Register-Stop messages in response. It is normally the local
loopback interface address, but can also be a physical address. This address must
be advertised by unicast routing protocols on the DR. The configured interface
does not have to be PIM enabled.
Mode Global Configuration
Example awplus# configure terminal
awplus(config)# ip pim register-source 10.10.1.3
Command
changes
Version 5.4.7-1.1: VRF-lite support added SBx8100.
Version 5.4.8-1.1: VRF-lite support added x930, SBx908 GEN2.
Parameter Description
<source-address> The IP address, entered in the form A.B.C.D, to be used as the
source of the register packets.
<interface> The name of the interface to be used as the source of the
register packets.
To Next Page
Loading...
Need help?
General
